Opinions on Rivco Aero Pegs?
Anyone with the Aero pegs installed that is 6'3 (32 inch inseam) or taller? I just ordered these and am a bit concerned that I might feel a little cramped in the peg mounting position furthest away from the rider. I put my feet up to where they will be mounted and it felt a little high and not forward enough. Anyone??
On a side note......John from Rivco has been a pleasure to deal with so far. He has addressed my questions and even went as far as to contact someone with these installed and is sending me some pics of himself (he is the same height as me) with his feet on the pegs. That's customer service! I hope to have the pics later on today......
was concerned about removing parts, valve cover?
I was concerned when I bought these that I'd have to remove some critical engine part to install these.
Not Even! it was super easy and took me 30 minutes. 2 allen wrenches, 1 large flat screwdriver & a old t-shirt to cover the tip of the screwdriver...
I'm 6'2", 32" inseam and I mounted these in the full forward position. They are great, I can put my foot either on the peg or rest the back of my heel on the peg and "Air out my Junk" ,:icon_wink: absolutely wonderful!
Apparently, the color problem has been corrected as mine are "black" not purple (or so I thought but I cant tell the difference between blue and black socks, So?)
I also thought that the position looked high, but my former ride, a Suzuki Boulevard had highway pegs and I had them about the same height off the ground..
I can also open these with my boot, or by reaching down and grabbing them by hand, tried it yesterday while cruising down US23. No Problem...
I recommend this product !