Quote Originally Posted by tpwood View Post
You do have to cut wires, if you look at the directions near the bottom of the instructions, the F6B requires cutting the end connectors off the splicing them to the factory wiring. Just installed mine last week.

**NOTE: FOR 2001-2005 GL1800, F6B AND VALKYRIE MODELS YOU WILL NEED TO CUT OFF THE END WITH TWO CONNECTORS AND SPLICE THE RED WIRES FOR EACH
TURN SIGNAL, THE BLUE WIRES FOR EACH RUNNING LIGHT AND THE BLACK WIRES ARE FOR GROUNDS

So the Red wires splice to the solid color wires (Orange for left and Blue for right), the white stripe wires are the running light (blue) and the ground wire, green goes to the black wires.
I obviously was wrong, the new version comes with plugs for the newer GL1800 which has different connectors then the F6B. So you just cut the connector off that comes on it and splice into the existing wires.
We have had very good feedback on these.