Quote Originally Posted by luckyluciano View Post
Is there an easy way to adjust the slip tubes? They seem not to turn much when getting them closer to where the heat shields will fit right. How did you actually turn them...by hand? Did you actually have the rear hanger bolt installed but not tightened?
Correct, I installed the hanger bolt and slipped the nut on a couple of turns. BTW, if it's only a millimeter or 2 just loosen up the CAT/header side and slip it back on the exhaust/CAT end and re-tighten. If you don't want to do that if you have a DREMEL ream out the hole on the flange for the hanger bolt to move forward the mil. or 2 you need.