Anyone using that adhesive mount plate for the Sena 20S? My F/F Bell brain bucket is giving me great challenges with using the normal compression plate mount.
The Sena 20S adhesive plate uses 3M double sided tape.. though it looks thinner than what I normally use for other accessories.
Anyone lost a Sena 20S due to the adhesive plate failing? Or will it stand the test of time and wind velocity?
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537
After the second plate came off my schuberth c3 pro, I finally fixed it with 2 component glue
So you used an epoxy?Originally Posted by Winston
I may do they very same thing. Contemplating...
I do have some extra 3M double sided tape pads that came with my Ion camera's mounts. They adhere phenomenally well... haven't lost a camera yet
I think I will remove what Sena applied on the plate and try use the Ion 3M adhesive pads instead.
I would guess that the headphone and mike leads would act as some sort of temporary tether... in case the plate adhesion did fail on the side of the helmet... hopefully giving me enough time to grab the Sena before it blows off for good.
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537
I didn't have great luck with the double sided tape for the Senas. I did use some black RTV sealant as an adhesive . Just have to let it cure over night. Worked well. Nice thing about the RTV sealant or silicone, it is removable.
"Go sell crazy somewhere else, we're all stocked up"
Thanks JimmyTee... that's a good idea as well!
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537
I've used it in a few situations where I wasn't sure I wanted to commit to an epoxy. I said overnight, but I would make it a full 24 hours.
"Go sell crazy somewhere else, we're all stocked up"
Posting Permissions
Reply With Quote
