I recently had the misfortune of having the end of my left hand grip damaged along with a few other parts while a friend of mine was riding my 2015 F6. (Thank God he wasn't hurt. But that is another story.) The OEM heated grips are a PITA to get off in the first place, but after managing to get everything apart (primarily to figure out how all of those parts that make up the "handlebar weights" go back together) I discovered that the wire for the heated grip follows the handlebar down pass the triple clamp where is disappears into the abyss of wiring and plastic that covers the bike. The service manual says that in order to get access to the connector you have to remove the right side radiator and everything else that goes with it. (are you kidding me?) My question is... does anyone have any tricks that will allow you to get to this connector without taking apart the entire motorcycle? (Yes I know that I could just cut the old wire and splice the new wire into it. But I just don't like the thought of cutting the wire off of a brand new $120 grip in order to cobble it back together) Thoughts?