Finally installed the auxiliary fuse block I had laying around and a 6 gauge ground bus to get rid of some inline fuse holders and clean up the battery terminals.
Pulling some extra wires for some future mods while the bike is open.
Wired up some Baja Design Squadron Pro spot lights (with interchangeable beam patterns [wide cornering, combo or spot]) similar to what srt8-in-largo did.
I have a Skene 175 controller that may go in next if it is needed after some day/night tests. The Skene offers 3 different programmable brightness levels (in increments of 10% ranging from [0-100]%) as well as full bright if hooked up to a +12V source like (horn, high beams, momentary switch, etc.). They can also be programmed to turn off when the high beams are enabled.
Squadron Pros:
- 2 x 4,200 Lumens
- 2 x 42 watts
I have a couple 4,900 Lumen H7 LEDs high beam replacements waiting to go in once I get some H7 male pigtails.
I rode mine.
Not very often do the temps get into the 60's this late in December in Detroit.
Couldn't pass up the opportunity, did just under 200 miles.
Attachment 18035
Monkey around with vinyl wrap.
4 Wheels Move the Body
2 Wheels Move the Soul
In Loving Memory of My Brother
"Death Waits In The Dark"
2013 F6B Deluxe
Attachment 18036
I did this in miles today from home, around CT and back. This is on a short day because of the lack of daylight. The miles are adding up. I'm going to kill it next year.
I know, I need an ipod. My buddy connected his and now I have to have one.
“Gibraltar” 2016 white deluxe has been sold.
Did a 200 mile round trip with some buddies for lunch down to a great tiki bar (Bert's) on the water in Pine Island.
Tested the new Baja Designs Squadron Pro driving lights tonight on a variety of roadways. They definitely need a SKENE controller to get the most versatility out of them. The controller will be going in next.
Super bright led brake lamps installed.
“Gibraltar” 2016 white deluxe has been sold.
Fitted SoCal Low beam HID's.
Ooohhh: Shinny!
Now to be bothered fitting the HID low beam cutout loom.
I hate how much mucking around it is to remove a seat with the OEM rack.
Merry Christmas everyone.
Ken
2015 Blue F6B
Cairns AUSTRALIA