Dragger's

[Hook]

I didn't want to to cause a big stink over these. I didn't tell anybody to buy!!! So everybody need to take there stock acorn off then because they put out sparks if you lean to far. I ride my bike like I stole it and I scrap my pegs. If you don't like them for what ever reAson.... DON'T BUY THEM!!! HOOK

[Steve 0080]

http://secure.billydump.com/store/in...&productId=274


Here is the link for those who want to start the 4th of July early!!!

[Hornblower]

http://secure.billydump.com/store/in...&productId=274


Here is the link for those who want to start the 4th of July early!!!

Hey Steve--

Do these have the right threads for our bikes? If so, I'm ready to celebrate the 4th early

[Wild Bill]

Just wondering...The f6 has the ability to corner hard enough to fold up the foot peg in a turn. What happens if you catch a pot hole with the dragger or hear in Ga a center line reflector??? By by foot peg.

[chipmaker]

Just wondering...The f6 has the ability to corner hard enough to fold up the foot peg in a turn. What happens if you catch a pot hole with the dragger or hear in Ga a center line reflector??? By by foot peg.

Same as any other bike?

[Steve 0080]

Hornblower...YES 6x1.0 let the fire works begin!!! All kidding aside, on the occasion that you do drag a peg the sparks are really cool....I used to do this leaving the baseball diamond with my cleats!!! Brings back memories!!!

[Hornblower]

I was pretty happy with my "Draggers" and riders behind me said they could see some sparks. Due to the long cylindrical design, I had some reservations about the length and also about how they would hold up. I can't honestly say I had any problem at all but then, I ran across Big Dawg at the Franklin rally. He showed me the Peg Saver Pucks from pepsX Products. Personally, I like this design much better and no doubt, these are much more substantial and, of course, more expensive. Have a look at the two side-by-side:



The Draggers require no modifications to install and simply replace the stock acorn nut. The Peg Saver Pucks do require drilling a 5/16" hole and cutting away a small portion of the rubber peg cover.