Belly Pan...Is there a need?

[Deer Slayer]

Hornblower you just saw mine. tee hee.....

[Hornblower]

Hornblower you just saw mine. tee hee.....

Many outside influences are draining my bank account and yes, you are one of them When I first bought this F6B Goldwing, I had no idea there would be so many ways to spend money on it. It is fun though, isn't it?

[Steve 0080]

Here is the EML address to the gentleman who makes the heavy duty belly pans.... macgyver0856@sbcglobal.net he charges for shipping and to me in Orlando the total cost was $56 ... this guy makes these by hand and there is a delay in shipping...right now he is working on a list of 65 ...so must be a good product..... I was not going to buy one, but after seeing all the pic's of damage and the water bottle " right " there...why not ?

[Steve 0080]

Here is the EML address to the gentleman who makes the heavy duty belly pans.... macgyver0856@sbcglobal.net he charges for shipping and to me in Orlando the total cost was $56 ... this guy makes these by hand and there is a delay in shipping...right now he is working on a list of 65 ...so must be a good product..... I was not going to buy one, but after seeing all the pic's of damage and the water bottle " right " there...why not ?

I received a PM on this belly pan and here is a pic and the eml address to order one...they were on Wing Stuff....I'll look in a min and post if they are. As belly pans go..this is a nice one and very thick....I use it to lift the F6 off the ground with my lift...perfect. For those who do not care for the chrome...the maker will paint your black!!!

[Steve 0080]

Here ya go.......


http://wingstuff.com/products/36093-...?from_search=1

[XKnight]

I installed the black anodized belly pan today. Mine definitely didn't just slide on like the instructions said. I had to use my trusty rubber mallet to get the slots to line up. Also had to remove the bolts all the way per the instructions so I could see the belly pan slots when they were in the correct position. My only concern now is that the 2 small screws that hold the front part on will come off while riding. Haven't heard any reports of that yet, but will add some blue loctite just in case.

[Scotrod]

Most of the time, the complaints revolving around the 2 screws is that they are impossible to remove, not that they fall out.

I'm trying a different approach; http://hondaf6b.com/showthread.php?3...hlight=redneck

[rich]

I installed the black anodized belly pan today. Mine definitely didn't just slide on like the instructions said. I had to use my trusty rubber mallet to get the slots to line up. Also had to remove the bolts all the way per the instructions so I could see the belly pan slots when they were in the correct position. My only concern now is that the 2 small screws that hold the front part on will come off while riding. Haven't heard any reports of that yet, but will add some blue loctite just in case.

Mine did come partially off while riding, first good turn and was dragging. By the time I pulled over it was bent to hell. Good idea with the Loctite.

Rich