Modulating headlight debate

[K/W Motoman]

I contacted Kisan about using low beams for modulating and they said no problem.
I asked about using a switch on the light sensor cable to be able to run the lows without modulating and that was no problem as well.

Here is his answer:

Mark,

Switch needs to in-line with just one of the wires.

Slit open the black jacket of the Sensor cable
Use the Black wire inside to hook-up the toggle switch
Switch ON to allow modulation - (closed position)
Switch OFF to stop modulation - (open position)

Good luck.

Andy

This what I will be doing. Now looking for a waterproof toggle switch.

[woody]

It is illegal to fit them in Australia because other motorists mistake them for emergency vehicles.

[ShanghaiDan]

It is illegal to fit them in Australia because other motorists mistake them for emergency vehicles.

Crazy Aussies! I bet you even drive on the wrong side of the road!

[woody]

Sure do.

[thumper 549]

It is illegal to fit them in Australia because other motorists mistake them for emergency vehicles.

I am my own emergency vehicle. LOL
I have LED driving lights mounted to the top of crash bars on the road king.
At the press of a button, they go full wigg wagg .
Intersections and LEFT turns-, - if not careful they will kill ya.
The Wig Wagg lights are just enough to bring most them out of their Cheeze burger trance to almost notice ya!.
Even so, I count on every one of them doing the wrong thing.

[crossbowme]

I am my own emergency vehicle. LOL
I have LED driving lights mounted to the top of crash bars on the road king.
At the press of a button, they go full wigg wagg .
Intersections and LEFT turns-, - if not careful they will kill ya.
The Wig Wagg lights are just enough to bring most them out of their Cheeze burger trance to almost notice ya!.
Even so, I count on every one of them doing the wrong thing.

X2