My F6B is to Hard no matter where I set rear Shock, Has anyone found some changes I can do front and rear to make it ride like a Gold Wing
I love my bike but want it softer , JB
My F6B is to Hard no matter where I set rear Shock, Has anyone found some changes I can do front and rear to make it ride like a Gold Wing
I love my bike but want it softer , JB
I'll be interested to read the responses to this thread. My rear pre-load is set at full soft and I also think the ride is too firm. I weigh 230 lbs, probably 240 with gear on.
Former Ride:
2013 F6B Standard, black; sold 7/2019
Latest Addition:
2016 Gold Wing Level 3, red; SCT transmission stuck in manual mode
2019 Miles:
7,900 as of 10/6
Opinions vary on this. Medium setting makes this the most comfortable bike seat I have ever had. Rode 915 miles in one day from Orlando, FL to Parkersburg, WV with no issues. I am about 200 lb. 5'8. I also have a Bridgestone Driveguard rear tire at 28--30 lbs whicch creates a softer ride and still handles great on The Dragon.
Please explain.
Based on my understanding, the spring controls the shock. With the preload minimal, the spring is not "pre"-compressed, allowing the shock to have its full stroke. By increasing the preload, the spring becomes compressed, controlling the motion of the shock, and preventing the shock from easily extending and compressing its full travel.
This, in turn, creates a firmer ride with the shock less "free" to use its range of motion.
Former Ride:
2013 F6B Standard, black; sold 7/2019
Latest Addition:
2016 Gold Wing Level 3, red; SCT transmission stuck in manual mode
2019 Miles:
7,900 as of 10/6
Actually, no, the spring doesn't control the shock, the shock controls the spring (it restricts the free movement, the natural frequency, of the spring), dampening or restricting the movement but not restricting the distance the spring can move. The adjuster that is provided on the F6b is a spring preload adjuster, not a shock damper adjustment. With the preload set at minimal, the spring is not pre-compressed (it actually is, but for the discussion here we will assume that it isn't) and as soon as someone sits on the bike, the spring sags (compresses). With minimal preload, the spring compresses more - therefore leaving less travel to absorb bumps. In other words, it bottoms out the suspension sooner. If you crank up the preload, the spring now doesn't move as far when initially loaded with the rider, leaving more travel to absorb bumps.
As an example, if we have a total of 4 inches rear suspension travel (not spring travel, the suspension itself as limited by the shock travel), and there is no preload dialed onto the spring, the rear suspension may sag 2 inches with a 200 pound rider. That leaves only 2 inches (like a Harley) of travel left out of the 4 inches total to absorb bumps. Then crank up the preload so the same 200 pound rider only compresses the spring 1 inch, there are now 3 inches of travel left to absorb bumps. This is a very simple example, and assumes that the spring is a straight rate spring as opposed to a progressive rate spring (which it probably is), but the action is similar.