It was an easy job, but the instructions on final adjustment were certainly not written by any technical writer.
The instructions said to make sure the spacing between the outer side clamps and the inner brace were equidistant (my word).
What they neglected to say was make sure the spacing between the outer side clamps and the inner brace were equidistant both on the front and rear of both clamps. Someone could install the side clamps out of square if they followed Kury's instructions.
After installation I wasn't happy with the amount of the fork slider exposed to the elements and bugs. The Kury brace's fork shield doesn't extend as high up the fork sliders as did the factory plastic fork shield.
I installed a set of these. I had a set on my previous bike and they worked great at keeping dried bug guts and road muck from getting into the fork seals and cutting the seals:
Reply With Quote