Originally Posted by
stevenolts
I now have a problem with the left cubby push pins.
I installed the Ausie Cruise which made the left cubby very snug. Now I installed the Kuryakyn USB power supply which I connected to the power supply for the cigarette lighter in the cubby. I connected power to the wiring harness for the cigarette lighter not to the cigarette lighter. I made a cut the harness to the cigarette lighter only not the bike wiring. I soldered and used heat shrink tube. (this came out very clean and secure) I brought the wire out through the little gap in the cubby for the headphone harness. The cubby was already very tight / now it can barley be pushed in and the push pins connected properly. I went out to the bike this morning and the push pins were popping out. Luckily I caught this and did not loose any push pins. These push pins are the worst design (very cheap) I have always hated them when doing body work etc...
How would you suggest I fix this / should I expand the hole a little to accommodate the extra wire or find some way to fish the wire up under the handlebars another way?
I really did not want to disassemble the dash to do this. It is working now but the cubby is just too tight to connect the very unsecured push pins.
Steve