You need two sets, Low and High. A lot of people only replace the Low beams, but the high beams work incredible at night and can be seen about 1/2 mile away in the daytime. I can not imagine needing a headlight modulator if running the High Beam LED's during the daytime. We have people all the time comment on the Pathfinder LED Headlights on our F6B.

On the Red LED's for the rear. We sell the cheaper version mostly for other bikes. The LED's are behind a red lens that seems to be a little more difficult to see red through then normal red lenses. We have tried multiple bulbs on our F6B and the only bulbs to use are the Pathfinder unless you just want to go with a white LED behind the Red Lens. The Pathfinder are very bright and look great, expensive but far better then anything else.
The BackOff XP works great. With dual bulbs the BackOff WigWag I think gets people's attention a little better and is what we installed on our F6B. We have used all of the BackOff units. The WigWag Emits 4 alternating quick flashes of the left and right brake lights, followed by 3 short flashes and 1 long flash (3.5 seconds) of both brakes lights. The 3 short flashes and 1 long flash pattern automatically repeats itself as long as the brakes are held.

Hope that helps.
Rick

Quote Originally Posted by Hoff View Post
So I just got my 6 about 1.5 weeks ago. I've done some searching in the forums, but information is all over the place, and more about how great these mods are, not necessarily what parts are needed in actuality.

This is what I want to do.

Upgrade headlight to LED (Value Accessories part 226-0054)
Upgrade brake and rear turns to LED (VA part #7443RL or 7443A/7443R)
Add headlight modulator (Kissan part # P115W-D)
Add brake "flasher" (VA part # 28-01001)


My questions are these.

Headlight...one set of Pathfinder LED headlight kits or two? I'm used to my VTX that has one lamp, not 4. Since there are 4 lamps there, do I need 2 sets? And if so, what is the point of 4 lamps if two work as low and two work as high? Or do the new lamps go in the center as they are the low and stay on for high?

Headlight modulator, only need one that connects as master/slave setup for the dual headlights. Unless I'm way off here.

I know I need to replace the flasher for the turn signals, that's not an issue. But Value Accessories has two different 7443 lamps for tail lights. One is $20 each, the other is $7.95 each. The $7.95 one looks like it MAY be for the turn signal replacement as it possibly is red as a running light, then goes amber as a flasher (or the other way around?). Or do I just buy 2 of the red at $20ea and 2 of the amber at $20ea?

Any direction would be greatly appreciated.