can you post a picture of where/how the mount is attached to the bike?
thanks in advance...trying to figure out how it will look.
can you post a picture of where/how the mount is attached to the bike?
thanks in advance...trying to figure out how it will look.
ive used one of these for years. Never had a problem. 6 to 10 bucks on Ebay. it has a plastic plate on the back, just drilled a hole thru it for a Ram Ball. Less than 20 bucks total.
Attachment 7720
http://www.ebay.com/itm/WaterProof-M...item51c0c7c658
2013 Honda F6B #374 (darksided)
2004 Honda NRX1800 RUNE #274
2008 Can Am Spyder #21 (basically factory darksided. )
1989 Kawasaki KZ1000 Police
1992 Yamaha FJ1200
I don't have a picture but I can get one shortly. You can see that the aquabox has the RamMount base plate attached. I used the RamMount Clutch/Brake Resevoir base and placed it on the clutch reservoir because I have my power coming from the left cubby using the 12v power outlet.
http://www.rammount.com/CatalogResul...5/Default.aspx
I tried this base mount which attaches on the front but I found that it brought the GPS too far forward for my liking. http://www.rammount.com/CatalogResul...ault.aspxusing
20140816_164704.jpg
I ran power from the accessory terminal on the fuse block along the frame and up through the triple tree, under the cover on the handle bars and out. I still need to rework the last bit as I couldn't get the shrink tube over the solder joints and the red and black wire show.
thanks