What did you do to your F6B today?

[yardart]

I installed the 13inch wind bender today, took the gas cover off for the painter , getting the black panel that license plate is mounted on, painted red 201

[ths61]

I installed the 13inch wind bender today, took the gas cover off for the painter , getting the black panel that license plate is mounted on, painted red 201

Give us a report on the wind bender after you have had time to test it out.

[srt8-in-largo]

... , getting the black panel that license plate is mounted on, painted red 201

Just for reference, Honda calls that panel the "rear fender".

[okf6b]

I installed Steve's backrest riser. What a great accessory! I wasn't thrilled with the exposed hex bolts. Ace Hardware had some 1/2 plastic tips that I trimmed to height for a more finished look.

Thanks Steve.

Attachment 13927Attachment 13928Attachment 13929

[flat6bagger]

Looks like a trip to ACE for me today.
I have been bothered by this look.
The backrest is a "must have" to make a passenger happy.

[flat6bagger]

Went to ACE,got the tips and didn't cut them down.
I just popped them on and called it a day.

[okf6b]

Went to ACE,got the tips and didn't cut them down.
I just popped them on and called it a day.

That works too. It's a definite improvement.

[hiflyer]

I installed Steve's backrest riser. What a great accessory! I wasn't thrilled with the exposed hex bolts. Ace Hardware had some 1/2 plastic tips that I trimmed to height for a more finished look.

I covered mine too. Buddy the wonderdog helped

[stroguy]

Buddy looks fearrrrroshus!

[gmorstad]

+1 I ride clearview 19" with vent tinted!

I don't understand. After I got the upturned 16" Clearview sport I found it was too short and Clearview told me they didn't make anything bigger for the F6b.