E C tail lights

[shortleg0521]

I just installed 2 sets of EC tail lights. These are leds that you drill a hole in
your tail light housings and add one at each end.
Thanks to this forum I found that it works better to install two set rather than just one.
This is how mother Honda should have made our tail lights.
The job of course was made so much easier because of this forum
Thanks goes to Steve I think for the pictures and the placement of the second set.
shortleg

[F6B1911]

What about keeping the tail light water-tight?
How to the EC lights mount in/on/around the hole you drilled? gasket? sealant?
Got any PICs?

[shortleg0521]

What about keeping the tail light water-tight?
How to the EC lights mount in/on/around the hole you drilled? gasket? sealant?
Got any PICs?

They install with rubber sockets that fit tight to 1/2 inch hole that is drilled.
Also added a small amount of silicon around the socket .
Here is what I am talking about
http://hondaf6b.com/showthread.php?2037-Turn-Signal-Conversion-Kits&highlight=rear+lights

[Steve 0080]

Your Welcome Shortleg!

The lights are in an area where water does not get to...if/when you pull the back of you will see dust and dirt as it is a dry area !!!