PDA

View Full Version : ODO and TRIP disappeared!!!!


The Swede
08-23-2015, 09:12 AM
This happened when I took a ride today, I noticed that the TRIP A/B was reset and started to count from zero again (should have been 300 km something but was only 110 km). After the next stop when I turned on the ignition both the ODO and TRIP was missing (See picture) speedo works as it should when I driving.
Have this happened to anyone else??

15886


The Swede :icon_cool:
lloydmoore1
08-23-2015, 11:05 AM
Are you riding the black F6B ? Then maybe it's " blacked out " ?? :yikes:
Hey might as well have a laugh but no I have never seen this but I'm sure the fix will appear soon cause there is a lot of help on this site. Good luck!
stroguy
08-23-2015, 11:18 AM
Disconnect battery.....reconnect....reboot.
Steve 0080
08-23-2015, 12:37 PM
+1....leave off for 10 mins....( just one lead )
shooter
08-23-2015, 05:49 PM
Remove the negative cable not the positive.
The Swede
08-24-2015, 09:44 AM
First I must admit I did not read the tips properly, so I disconnected the battery completely the first time.
Problem not solved, then I read the tips again, and saw that I missed that it was only the negative lead that would unplug,
down to the garage again and do it right, but no luck this time either?!

The Swede :icon_cool:
Fla_rider
08-24-2015, 09:48 AM
I wonder if his connection in the rear has come partially disconnected? Well whatever it is, it's got to be covered by warrenty.
stroguy
08-24-2015, 10:18 AM
It's typically easier to disco the negative as it may be one singular cable. The intent is to interrupt the power to the bike fully and then reapply power to reboot all systems. It is good to leave it disco'd for a few minutes to ensure all power is bled from the system. Now if you rebooted and still have the issue you may have a disconnected cable input to the computer or your computer has had some failure. It's time for some warranty/servicing from a technician.
coffee_weasle
08-24-2015, 01:24 PM
trip odometers reset randomly, and as time has gone by, i can not get the temp to display unless i hit setup button to get the invalid error to display, then i get the temp.....

this november it's going in to get it replaced under final year of the warranty