Honda Marine volt meter wiring loom fit

[Baytown]

G'day everyone.
I fitted the Wingstuff genuine Honda marine volt meter and replacement panel today, but could not work out where to attach the wiring connectors ( power and earth) in either of the two wiring loom points located in the rubber boots on the right access panel , rt side of the fairing.
There are two separate white connector blocks with black caps ( with three vertical brass pins). My wiring connector on the volt meter has 2 pins in a horizontal plane. Do I use the small white connector block, and splice into it for power to the gauge, or is there a location that the two pin horizontal gauge connector will just plug in to? Unfortunately the online instructions were no help.
My bike is a 2015.
Thanks for any advice re this, as I was expecting simple plug and play.
Ken

[F6B1911]

There is a link to the installation instructions right on the Wingstuff webpage for the voltmeter, http://wingstuff.com/products/29399-volt-meter-with-back-panel

http://wingstuff.com/system/uploads/pdf/000/002/365/original.pdf?1331818668

[Wing'n it]

I think that if you have the Honda heated grips it plugs into that connector and if you don't have the heated grips then you have to purchase a separate harness extension to jump to the left side pocket connector.

[DaWadd]

I tied into the heated grip power supply since I don't have them on my bike. Easy. Service manual helps.

[Baytown]

Thanks fellas. After a bit more research, yep, looks like I need to purchase the extra wiring harness to get to the left pocket area.
Bugger!
Thanks and best wishes all.
Ken