F6bisnext
01-03-2016, 09:21 AM
I have analysis paralysis and have read almost every post on rear lighting I could find. Here is what I am looking to do, the parts I bought and I would appreciate your suggestions on what else I need to get all the parts to finish it. I don't do electrical work, so this will be done by the dealer, but I don't want to overpay for their parts.
What I want to do: Bright flashing brake lights. Make brake lights run turn.
What I have: TIR 3 with Kuryakyn wiring harness not yet installed and superbrite blinking led brake lights which I put in yesterday. I would like these to blink at the same rate not sure if it can be done or what would be needed.
What I need: Something to turn turn signals into run/turn or run/turn/brake. But I think the TIR3 and flashing superbrite may be all I need for the flashing rear brakes and it may be cheaper to go just run/turn. This is where I need the help. What lights for I buy, what else might I need...resistor? wig wag? Not sure as I am not electrically competent.
Thanks for the help. You guys ROCK!!!!
What I want to do: Bright flashing brake lights. Make brake lights run turn.
What I have: TIR 3 with Kuryakyn wiring harness not yet installed and superbrite blinking led brake lights which I put in yesterday. I would like these to blink at the same rate not sure if it can be done or what would be needed.
What I need: Something to turn turn signals into run/turn or run/turn/brake. But I think the TIR3 and flashing superbrite may be all I need for the flashing rear brakes and it may be cheaper to go just run/turn. This is where I need the help. What lights for I buy, what else might I need...resistor? wig wag? Not sure as I am not electrically competent.
Thanks for the help. You guys ROCK!!!!