Klock Werks Shield 2"s Taller
Sunday was the day to see if I sell the Klock Werks or keep it. So I drilled two new holes in it. One on each side. Not enough meat to drill a center hole. So for the Center I pinched the Shield with a large fender washer. I put a rubber washer under each bolt and tightened it down. Came out very sturdy and raised to its max. When everything is together it measures 15 1/4"s from the top of the rubber seal to the top of the shield.. This leaves the two stock holes above the seal that I will plug with a similar cap that I put in the Screw holes in the rear rack....What a difference at 85 mph. Smooth air...Klock Werks should make this shield 2"s taller. But until they do I'll ride her like it is.Still looks good and functions good too.........I know you guys want photos. So perhaps one of you will donate a nice camera.(Nikon maybe) Let me know and I'll tell you where to send it. Until then you'll have to use your Imagination.............................Dickie