OEM holes measure 1 3/8". Hertz spec says 25.mm which is an inch. I think they will snap right in.
Thanks for the measurement.Attachment 4962
Printable View
OEM holes measure 1 3/8". Hertz spec says 25.mm which is an inch. I think they will snap right in.
Thanks for the measurement.Attachment 4962
They will go in after you VERY VERY CAREFULLY cut the grills off. If you aren’t careful, you’ll wind up with the following, requiring an additional purchase.
You don’t want this....
Attachment 4963
This is after grill removal, trimming down the housing, wrapping with heavy duty two sided tape, and pressing it into place.
Attachment 4964
Ok, I got some dimensions on the tweeters. The stock tweeter is 1.41”, Hertz before grill removal is 1.49” but after removal is 1.42”.
Thanks Pilot,
Looking like I'll have to figure out how to get the grills off the HT 20 tweeters, to get them in the OEM grills, from the back of the grill.
Jim
I will try to locate some additional pics to send your way. Check your PM.
How do you guys have the crossover set?
+ normal or -
Thanks
Thanks Jimmie.
This new site is useless for searching old facts.
Do you remember what the polarity is of the rear speaker wires?
Left channel -
Blue / Red
Orange
Right channel
White
Blue
I don't remember off the top of my head. WOuld have to look at the schematic again. You could use a digital multimeter and play source material, noting which lead is attached to what wire. If the meter measures your DC voltage output as positive, you know ,by your meter leads , which one is positive and negative. I no longer us any of the factory wiring as my system is totally aftermarket now. The only thing stock is the handlebar controls.
As far as the crossover , I lefet mine normal. I can adjust individual frequecies through the head unit.