Installed Cobra 6 two 6 with Torque Loopz
Installed Cobra 6 two 6 with Torque Loopz this week 3/1/17 - definitely not a task for the light hearted and definitely not for those who are impatient. I chose the Cobra's for looks and sound after watching a lot of you tube clips etc... I chose to leave all the baffles in. I had to remove a good bit of plastic and shielding to get to the CAT's without damaging anything else - big advocate of measure 3 times and cut once. Everything went together fairly smoothly but it was difficult to eliminate exhaust leaks - I used some exhaust sealer to get it sealed. The exhaust transition covers were a bear to fit perfect and required a little trimming on the left side. Adaptation both slow at idle and cruising speed, took longer than expected and it seemed to help when I took the revs up to 4k rpm. No drone, no annoying wake the neighbors up bark - unless I nailed the throttle. I slight fart if I back off the throttle quick. Hoping I don't suffer the rust others have. This thread seemed a little old so anyone who wants to chime in with new Cobra info, please do.