Hey BigLry, did you add any extra gaskets or try anything that would keep them from loosening up?
Printable View
Nope, I just used the OEM gaskets, but paid critical attention to their placement on the male end of the exhaust header & mufflers as they slipped into the Loops and placement of the clamps. I also went through a heat cycle (started engine with all plastic off) then re-torqued all clamps after cool down.
I have not had any leaks nor has anything come loose after about 10k miles on them now. I set all my clamps so I could also reach & tighten them without removing any plastic in case there was anything leaking or loosening up, which thankfully has not happened.:icon_biggrin:
I must also note that I did switched out and used a more robust clamp on the muffler end, they were the ones that came with my Jekill & Hyde mufflers, but I had no problems with the OEM clamps before I installed the Jekill & Hyde system, I just wanted to use their clamp on their mufflers.
Attachment 19729
Thanks BigLry!
My loops showed up today. Taking notes now, was wondering how long to plan for install. I had all the lower tins off before so I am ok with that part, just wondering about headers and crash bars, anything there to watch for?? I read and will be gentle with O2 sensor and wire. Should all go ok as far as I can see.
Just take your time being especially careful how you seal that first joint. If Jimmy is still including gasket maker instead of muffler sealer, I would recommend buying some muffler sealer. Be very careful not to let the supplied gasket push in too far. You want that gasket flush with the edge. Also, be careful with the orientation of the clamps. If you don't install them right, you won't be able to fit the lower header covers back on. Another tip is to coat the rubber boots on the heat shields with silicone grease. That should help them slide back in place more easily. Good luck!
Thanks Ken, I will watch out for first joint, they sent gaskets with some sealer on them, but I will pick up joint sealer to make sure.
WHAT TYPE OF LIFT DID YOU NEED TO DO THE INSTALL?