Printable View
A few photos from this morning. Harder than I thought. Had to do some grinding to make it fit. Attachment 21200Attachment 21201Attachment 21202Attachment 21203Attachment 21204Attachment 21200Attachment 21201Attachment 21202Attachment 21203Attachment 21204
BTW, where can I get a black heat shield to match the exhaust? 2015/2016?
Looks very sharp!
Looks sharp Yikes. It looks like you have a similar gap as I did after the install between the heat shields and the lower cover. Curious what you had to grind?
I had to grind inside of the front of the pipe, so the coupler would fit in. Looks like the paint made it too narrow.
How do I close that gap?
Assuming the lower cover is fully seated in all the doo-dads at the header area, I'd suggest sliding the heat shield forward if you can any, assuming the muffler tabs will still be mostly seated in the stirrups. I did mine with torq loopz (still working on getting it right :icon_redface: :banghead:) so mine's a slightly different beast. Different attachment points for the shield and lower cover. With all the trouble I've had, if I can get it back together with everything else good, and I still have that gap, I'm going to call it a success and ignore it.
Where does the heat shield attach?
Hi-temp flat black paint...works fine.Quote:
Originally Posted by YikesCops
https://youtu.be/nmVDIRZhGnM
Got it installed, left was not easy.
Is that a 2004 or 2005 EB Rune next to the F6B?
2005
Looks good and sounds great! Nice work.
Get a can of VHT paint and paint yoursQuote:
Originally Posted by YikesCops
You have to take the heat shield off in front of it first and the front cowl.Quote:
Originally Posted by YikesCops
Sounds like a pain. Perhaps a project for a rainy day. I'll pop the HS off, paint it, and line it up better.
Question: Is the 2015 HS compatible with a 2013?