What is is everyone using for the lower driving lights? My F6B has the openings for them, but not installed. Hondaline, Pathfinder, Show Chrome? I'm looking for suggestions.
Thanks.
Printable View
What is is everyone using for the lower driving lights? My F6B has the openings for them, but not installed. Hondaline, Pathfinder, Show Chrome? I'm looking for suggestions.
Thanks.
In September of 2016 I bought the Value Accessories LED Rectangular Fog Light Kit #BP52-906 for $209.95
Installation was not difficult and required a couple of hours.
I am happy with the added visibility when riding at night. Mine are always on so that I am easier to see from the front even in daylight.
Have not had any issues and am approaching 30,000 miles on them.
I don't know if this kit is still available from them or not.
Adding lights is a really good idea no matter where you buy them.
Good luck.Attachment 7111
That's the Show Chrome kit and is available for a bit more money.Quote:
Originally Posted by billsim
Thanks.
I have the Hondaline ones and just recently put a yellow film over them so they look like yellow fog lights. I don't need to to see. I rather be seen and I think yellow will make me stick out a little more.
I went with the Show Chrome Tridium fog lights -- if you choose to go that route you can get lampguards to protect the glass for about $13 or so. Also made by Show Chrome. The lampguards also help to fill in some of the inevitable gaps between the light and plastic housing. Very happy with the look -- small driving light on at all times unless you switch to full fog light.
In April of 2018 I installed a set of the Tridium fog/driving/turnsignal lights from Wingstuff. I thought they were a pain to install. I ride in the dark in deer country daily. I keep the right hand light aimed to the right slightly to help illuminate the deer eyes in the fields before they get into the road and they work pretty well. They don't have quite the long range reach I wish they had but they do help.
I've put 16,000 miles on the bike since the install and have had no problems with them or anything else on the bike. Lots of rough roads, car washes and riding in the rain in that 16,000 miles too. https://wingstuff.com/products/37526...for-f6b-gl1800
Did not know those existed. Did you notice any reduction in nighttime light output with the lamp-guards?Quote:
Originally Posted by Brasco
I do my best to keep night riding to a minimum so honestly can't say I notice any difference in light output with the guards (as long as you keep them clean). They attach via small velcro tabs so extremely easy to take on and off as the situation dictates. Will send you a PM with further info.Quote:
Originally Posted by Frye
I installed the Electrical Connection low and high beam LED's and the EC LED turn signal kit a few weeks ago. The high beams......PITA.....everything else was not a problem. I called about 10 days ago to get the fog light kit and they had sold out and was told they are coming out with an upgraded kit in a few weeks. The EC fog light kit apparently could not be easier to install. Quite a bit simpler and easier than the SoCal Pathfinders. The light attaches to a steel plate that attaches to the low shelf of the cowl housing with 2 drilled holes and it's plug and play like the others. When they hit inventory, I'll be getting the EC fog light kit.
Lots of good information, Thanks. I'll do some looking into your suggestions.
Show Chrome's Tridium Light Kit.Quote:
Originally Posted by honda_dog
Install
On a scale of 1-5 with 5 being difficult, about a 2.5 for wiring.
Knowledge of wire splicing and soldering beneficial. (Kit is an adaptation for F6B but was designed for full wing)
I installed the same kit and at first I had some larger spaces but managed to fit and re-fit, and re-fit the lower piece so that the fit is snug all around each light. It was a royal PIA to fit the lower cowel though. A bike lift would have been nice on this job.Quote:
Originally Posted by Brasco
SoCal lighting for the win!
I installed the Honda LED cowl lights and after 6 years no problems. Work as intended and plug and play.
Same here, DaWadd.Quote:
Originally Posted by DaWadd
When I bought my 2014 new, they had a deal going where you got $X of "free" accessories (but were supposed to pay the dealer to install them). I selected the Honda LEDs, tossed them in the saddle bag and installed them when I got home. Wasn't too bad, since they're OEM and fit easily.
I installed Electrical Connection lights in mine. Basic plug ins.
Have SoCals on my Wing, VERY good lights. Installing Electrical Connection's product on the F6, just to try a different setup, not because I see any shortfall with the SoCals.
Do you prefer one system over the other?Quote:
Originally Posted by F6Joe
I installed the Honda OEM fog lights and am very satisfied with them. Additionally, I upgraded the headlights to PathFinder LEDs also so the light color matches and the combined brightness for DLRs is awesome.
I also have the Pathfinder fog and headlight. I just ordered the turn signals from pathfinder pkg. and will install soon. I like them for the running lights too.
Thanks Brasco, I bought these after you brought them to my attention. Many thanks for doing so. They look way better, protect the lens from rocks and don't hinder the light output in anyway I can detect. And I ride to work in deer country before dawn every morning if it's not raining or below 32 degrees. Thanks to the craziness this nationwide house arrest is causing me I even rode in one recent morning at 26 degrees. It was well worth it too!Quote:
Originally Posted by Frye