Locking helmet with micro-metric buckle to bike

[six2go]

Haven't found the right cable yet, but I was thinking of using a cable to run it through the chin bar of my new modular, loop it around the grab handles, & the lock the end loops in the F6B's helmet lock.

Something similar to the yellow/orange cable in this ad:

https://vancouver.craigslist.ca/rds/mpo/6005280063.html
C

This is the cable I use(the shorter one) and use it like you are saying. Only difference is that I use a small padlock.

http://www.aerostich.com/a-to-b-util...ft-cables.html

[2wheelsforme]

If you get one long enough you can also use it to loop through your jacket arm and that way lock up your bike jacket also.

[Steve 0080]

I had the "T" bars made like in post #7 and use a gun lock, and one of these..http://wingstuff.com/products/150-ha...helmet-holders


Do a search I have pics somewhere!

[olegoat345]

I did the cable deal too.
At ACE I got the 1/16" SS "wire rope" aka "cable", couple ft. is plenty. Made a nice size loop each end, covered it w/ heat shrink. It's long enough to go through the chin bar or "D" ring, down to the Honda lock, when sitting on the seat. I can coil it up & it sits around the gas fill neck. Also carry a TSA lock in case it doesn't want to sit on the seat. With the cable & TSA lock you can lock it in lots of places.
Plug: I have a XL full face NEXX only weights 2.8lbs, makes it EZ on the ole neck. Love it.

[six2go]

" I can coil it up & it sits around the gas fill neck. "

Hey, I like that idea. I've been carrying mine in the left side cubby. The gas cap area sounds super.