I just trimmed with a palm sander. I tried different ways and this seemed to worked the best. And yes, you have to drill a slightly bigger hole for the metric screw. I installed them "terminals down". I also just cut the old connector off and screwed the wire directly to the terminal but a better way would be to have some kind of pin connector. I didn't use any batting in the cavity but I did put on the foam they came with for the seating area. Also I re-hooked up the original tweeters in the speaker grill which I guess is optional.
Hooking up the tweeters in the grill will change the impedance of the load on your bike's amp which may cause a problem. If you hooked them up in parallel, it will drop the impedance very low and strain the amp.
Hooking up the tweeters in the grill will change the impedance of the load on your bike's amp which may cause a problem. If you hooked them up in parallel, it will drop the impedance very low and strain the amp.
Ah, okay. Thanks for the heads up.
Save a biker........Open your f-ing eyes!! (and get off your phone)
Your Kappa's have a tweeter low/high switch on them so you can attenuate the tweeters. They are bright enough by themselves that you should not need the stock tweeters.