A few photos from this morning. Harder than I thought. Had to do some grinding to make it fit. Attachment 21200Attachment 21201Attachment 21202Attachment 21203Attachment 21204Attachment 21200Attachment 21201Attachment 21202Attachment 21203Attachment 21204
BTW, where can I get a black heat shield to match the exhaust? 2015/2016?
Looks very sharp!
Looks sharp Yikes. It looks like you have a similar gap as I did after the install between the heat shields and the lower cover. Curious what you had to grind?
I had to grind inside of the front of the pipe, so the coupler would fit in. Looks like the paint made it too narrow.
How do I close that gap?
Assuming the lower cover is fully seated in all the doo-dads at the header area, I'd suggest sliding the heat shield forward if you can any, assuming the muffler tabs will still be mostly seated in the stirrups. I did mine with torq loopz (still working on getting it right
) so mine's a slightly different beast. Different attachment points for the shield and lower cover. With all the trouble I've had, if I can get it back together with everything else good, and I still have that gap, I'm going to call it a success and ignore it.
Where does the heat shield attach?
Hi-temp flat black paint...works fine.Originally Posted by YikesCops
Ken (Hornblower)
https://youtu.be/nmVDIRZhGnM
Got it installed, left was not easy.
Is that a 2004 or 2005 EB Rune next to the F6B?
Successful people build each other up. They motivate, inspire and push each other. Unsuccessful people just hate, blame and complain.
Posting Permissions
Reply With Quote
