Tried out the crash bars today,need some paint, recommendations?
Tried out the crash bars today,need some paint, recommendations?
POR 15..., check it out.
If you’re pulling them off, I’d just have them powder coated.
Check out Duplicolor and Colorite's site.
I once posted all the correct paint code and cross reference numbers on the old site.
Without the old site' search content, this new site is pretty a beached whale.
Krylon metallic black at your favorite hardware store is a pretty good match.
4 Wheels Move the Body
2 Wheels Move the Soul
In Loving Memory of My Brother
"Death Waits In The Dark"
2013 F6B Deluxe
Agree. We have lost so much valuable content and pictures. It should be a crime.Originally Posted by Dirtstiff's F6B
.
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537
My boo, boo was just on the bottom of the bars. I hit it with a sanding sponge and applied some rattle can Satin Black from Do It Best Hardware. Satisfies me and I'm picky.
I had some paint damage from road spray, salt etc on the down low part of the bars. It is hardly noticeable but I used flat black truck bed liner in a spray can. That stuff is tough.
thanks to all
ACE satin blk.
Last edited by Dirtstiff's F6B; 05-27-2018 at 05:06 PM.
4 Wheels Move the Body
2 Wheels Move the Soul
In Loving Memory of My Brother
"Death Waits In The Dark"
2013 F6B Deluxe
If you have just a few scrapes, as I did, I went down to the neighbourhood Harley dealer (for me, about 3/4 of a mile up the road) and bought a touch up bottle of Harley's 'Black Denim' colour. Not a precise match....but it's pretty close. Close enough that nobody ever notices the difference until I show it to them.
.....sT
Journeyman ATCS, retired
U.S. DOT - Federal Aviation Administration -- 1982-2012
--- Valve Audio: Use a transistor, go to jail .....it's the LAW!! ---
Posting Permissions
Reply With Quote
