Torq Loopz Install Manual in Color

[SeaSteve]

"JUNO.com" Wait...Let me get my stone tablet and bone chisel to send you an email to a domain that's THAT old!!!

I'm considering the Torq Loops because...Late last year...I hit a large rock with the front tire which kicked up and it dented the right side exhaust covers. It looked bad for the cover but the bike ran fine and I knew about how much space I had between the cover and the actual pipes. This week I got around to actually looking at the damage. Looks like I've got some small dents in the actual header pipes but nothing major. Worst is one of the bolt studs the header exhaust cover acorn nut goes on is bent also.

With Torq Loops, how much of the pipes are replaced. I'm asking because I can't see a connection point between the header pipes and the catalytic converter. My next website "stop" this morning will be an exploded view for parts.

[taxfree4]

"JUNO.com" Wait...Let me get my stone tablet and bone chisel to send you an email to a domain that's THAT old!!!

I'm considering the Torq Loops because...Late last year...I hit a large rock with the front tire which kicked up and it dented the right side exhaust covers. It looked bad for the cover but the bike ran fine and I knew about how much space I had between the cover and the actual pipes. This week I got around to actually looking at the damage. Looks like I've got some small dents in the actual header pipes but nothing major. Worst is one of the bolt studs the header exhaust cover acorn nut goes on is bent also.

With Torq Loops, how much of the pipes are replaced. I'm asking because I can't see a connection point between the header pipes and the catalytic converter. My next website "stop" this morning will be an exploded view for parts.

Juno was free back then, I've been a member 20 years now I think. Anyway it cuts out a large piece of pipe, including the cats so you figure it actually comes pretty far up the header right where they converge into one pipe. I attached 2 shots from under the bike and you can see where the clamp is that is the mouth of the Loopz so about 3-4 inches after the converge weld