Well it was clouds and lots of rain today. So I pulled the left side header pipe off so I could get to the inside of the cross over. You will have to un plug the O2 sensor. It's plug is behind and slighty below the audio controls. I noted the crossover is the same id as muffler inlet. Rather than fully block the crossover I chose to weld in a disc with holes. The disc has lots of 1/8 holes. This will pass pressure and not as much noise.
I then installed my hooligan Honda GL1800 mufflers. This extra set has the front baffle removed and 3 extra holes on the outlet for a total of 4 outlets each.
Next I removed the single pipe baffle from both tips and install them. I love the sound. I do not hear any drone. 5500 rpm shifts will put a big ass grin on your face. The rolloff from 5500 rpm is also sweet.
Now I have to get Hornblower to ride my F6B and give me a grade.
Tune in for later update.
Yes I did ride in the rain..