I installed the 960 lights from BikeMP3 and have the green switch from EC but I am unsure where to tie the switch into the lights under the radio panel and how to mount the switch to the panel? I pulled out the radio control unit and the glove box but could not see how to attach everything. Help needed!
I figured out that the back panel to the radio control unit just pops off. Got the switch installed but I still can not find where to plug it in at. I called BikeMP3 and they said that it is in a clear protector under the radio control panel but I can not find it. Does anyone else know where it might be located or have some helpful advice?
Yes, it's there. Try looking down below where the cover goes.
Ken (Hornblower)
Look for a 'clear' (semi/foggy) flexible plastic 'bell-like' booty with the wiring harness running ~down~ in the top end.
Its basically open on the underside,,, Used as a 'water shield' to keep blowing water off the connections.
There is a much smaller one just underneath/forward of the LH cubby where the aux audio input is plugged in.
You're looking for a larger one semi-sorta behind the audio control panel and a bit 'forward'. Plug you're looking for is inside.
(Disclaimer: I've never been in on my audio panel. Response based upon prior reading)
Did you find it????
Ride it like you stole it
No, all of the clear boots have wires already connected. I found the one for the power/audio aux connection but have not found the one for the cowl lights. The lights plugged into the connectors, they were where they were supposed to be but I have not found the switch connection. I think the dealer hide it from me just to screw with meOriginally Posted by F6B-RICH
Did you find it????.
The clear boot is the one in the pictures.Left side bottom.Hope this helps.I had to yank the boot up pretty hard to find the empty plug wire
Posting Permissions
Reply With Quote