Billet Badges in reflector locations

[Hambly434]

I only have the fronts figured out so far.
Unbolt the reflector and bolt the badge in its place.
$35 a pair. For brushed alum. That would cover shipping and SS stud. Should use stock nut and washer.
Have material on order to make a run of them.
Will have a quote from anodize company by the end of the week.
They will anodized black then engraved.
Just wanting to get a idea if anyone would be interested
Before doing the rear ones also was thinking of a license plate bracket.

[Cool Hand Luke]

I want a pair. Would black anodized mean the plate is black while letters will be in aluminum color? If so, it may be even nicer. I think it would look great as a pair front and back. Maybe do a cover for replacing a small red reflector in back above license plate. Thanks.

[Hambly434]

Correct the engraving will be an aluminum color. Don't know cost of anodizing yet. As soon as I do I'll let you know. Just looked at the one below the license plate light last night but haven't unbolted yet. Bike is at shop for first checkup. Going to get it now.

[BLACKBETTY12]

I want a pair. Would black anodized mean the plate is black while letters will be in aluminum color? If so, it may be even nicer. I think it would look great as a pair front and back. Maybe do a cover for replacing a small red reflector in back above license plate. Thanks.

Sounds good!

[BACA]

I'm interested......I'd like the black with aluminum engraving if you do em.

[Cool Hand Luke]

Looks like I'm in for black anodized engraved pair. Also would like to get the rear pair, as well as rear reflector cover if you end up making it, so five total for me :-)

[Hambly434]

Just a update. Front fenders and rear under the license plate light are all the same. I'll work on the bags this week.
The plater has a 100 part minimum. So, sorry that's a no go at the present time.
I only bought 1 12' bar of stock to start with.

[Cool Hand Luke]

I definitely like your new F6B engraving better! I am interesting to see what the saddlebag reflectors will look like.

[Hambly434]

Thanks. The first set I did last week I just used the font available in the software. I had to draw this from scratch tried to get it close without being exact. I'm not quite sure how the trademark laws work but I don't need any problems.
I did pry off a bag reflector they are held on with tape. I'll try to get one done this week. They are smaller plus have a angle on the back also a orientation groove. The first set will be a pain but after that should be good.

[Hambly434]

Here's some more test parts.
Pm if your interested