Riding clothes - Page 2
Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Riding clothes

  1. #11
    Junior Member
    Join Date
    May 2013
    Posts
    11
    Quote Originally Posted by Wingman View Post
    Northeast? If you are close to Fall River Ma go to Vanson Leathers and check this out...http://www.vansonleathers.com/prod-S...cket-488.aspx? I grew up in New England and never rode in weather as hot as I see in North Carolina now, and this jacket works just fine for me.

    I know...the price, they will typically sell cheaper at the store than online.
    Thanks for the Vanson idea. I bought a leather jacket from them before and like to support the local(for me) businesses.

  2. #12
    Senior Member Darkknight's Avatar
    Join Date
    May 2013
    Location
    Enfield ct
    Posts
    345

    Neotek

    Quote Originally Posted by Bruce B View Post
    I'm considering a Neotek to replace an aging helmet and am hoping to find something someting that doesn't have that loud wind resonance. I'm riding behind a 13 inch Cee Bailey's (I'm 5'9", wearing a full face HJC) and there isn't much buffeting, just the resonance. When I open the face shield, the noise stops. A friend with an Arai has the same issue. I'd like to think that an up to date Neotek would solve the problem. What's your experience been? Has anyone had experience with the new HJC modular?
    I was using an HJC full face and I liked it except it was hot and if you sneezed there was a problem.
    Next I had a VERY inexpensive BILT modular helmet. That was incredibly noisy and an uncomfortable fit.
    I use a UCLEAR boomless com system that is bluetooth linked to my cell for calls and navigation. I could barely hear it in the Bilt helmet. It has noise cancelation so if I yelled to overcome the wind noise in my ears from the helmet, the system would try to cancel my voice. the Neotek is so quiet, talking on the Uclear is just like sitting in my living room and speaking to someone sitting next to me.

    Generally, Modular will be noisier than a full face. But you get what you pay for. The Neotek was the most expensive helmet I've ever purchased. The build quality is very good. the face shield seal actually seals. Noise levels will increase slightly with each vent you open. With all vents open it still very quiet compared to the cheaper helmet. So quiet in fact, that when I attached the UCLEAR module to the outside of the helmet, I could hear the turbulance it created, and UCLEAR is a very small module.

    It is definitly a comfy helmet and I've never worn a helmet with this much air flow inside. It also has a secondary shield that just about eliminates fogging, and the flip down sunshade is wonderful since I wear glasses.

    There are videos on Revzilla.com about different brands they sell, and head shapes Vs brands and they ship very quickly at least to the north east. (I ordered at 5:30 pm on a Thursday and it was at my door at 6PM the next day. regular shipping). They will also pay shipping both ways if the product isn't satisfactory (too much noise)

    I run the stock windshield and I'm 5'10" and 220 lbs. No turbulance in my head area, just around my chest. I do have an arthritic neck so my helmet shaking would be a significant discomfort.

  3. #13

    Neotech Helmet

    Quote Originally Posted by Darkknight View Post
    I was using an HJC full face and I liked it except it was hot and if you sneezed there was a problem.
    Next I had a VERY inexpensive BILT modular helmet. That was incredibly noisy and an uncomfortable fit.
    I use a UCLEAR boomless com system that is bluetooth linked to my cell for calls and navigation. I could barely hear it in the Bilt helmet. It has noise cancelation so if I yelled to overcome the wind noise in my ears from the helmet, the system would try to cancel my voice. the Neotek is so quiet, talking on the Uclear is just like sitting in my living room and speaking to someone sitting next to me.

    Generally, Modular will be noisier than a full face. But you get what you pay for. The Neotek was the most expensive helmet I've ever purchased. The build quality is very good. the face shield seal actually seals. Noise levels will increase slightly with each vent you open. With all vents open it still very quiet compared to the cheaper helmet. So quiet in fact, that when I attached the UCLEAR module to the outside of the helmet, I could hear the turbulance it created, and UCLEAR is a very small module.

    It is definitly a comfy helmet and I've never worn a helmet with this much air flow inside. It also has a secondary shield that just about eliminates fogging, and the flip down sunshade is wonderful since I wear glasses.

    There are videos on Revzilla.com about different brands they sell, and head shapes Vs brands and they ship very quickly at least to the north east. (I ordered at 5:30 pm on a Thursday and it was at my door at 6PM the next day. regular shipping). They will also pay shipping both ways if the product isn't satisfactory (too much noise)

    I run the stock windshield and I'm 5'10" and 220 lbs. No turbulance in my head area, just around my chest. I do have an arthritic neck so my helmet shaking would be a significant discomfort.
    I have the new Shoei Neotech Helmet and love it for all of the same reasons listed above. I have a baggershield windscreen that is 13 above the top of the rubber strip. I am 5'7" and the air hits me right on top of the head. Perfect for the massive air flow that this helmet provides. You will hear noise with all vents open and shield cracked open. Everything closed the helmet is quite and comfortable. I also looked at the Scheuberth helmet but it was 200 more and I could not see it being worth the price. I have no regrets with my Neotech!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •