Finally got some time yesterday to get back on this. Ran into problem bundled the harness and connections forward of the audio box, but I have the stock seat and have no room in between the bottom of the seat and upper rear fender. Just removed the stock audio box completely and turned 888b unit the connections facing to left side of the bike, allowing the factory wiring to come more to the rear. I see that you have a Corbin seat and I know another person was able to put a couple of small amps under there with a mustang seat, no way with the stock seat. Also haven't got the PAC yet, been reading up on the instructions with them and also with yours also. The big ??is which resistors did you put with those wires - and were they the ones supplied with the PAC unit? I'm good more with plug and play and fabrication, but when it comes to figuring that out is above myself even with your detailed instructions. That's my update so far and again thanks.