Here is a pict of Baja Design's "wide corning" light pattern:
Attachment 14037
Here is a pict of Baja Design's "wide corning" light pattern:
Attachment 14037
Yeah they're pricey; for what they cost the engineering sure better be as thorough as they claim... mechanically, electrically, optically, and thermally.
I took a quick look at the power budget on our bikes, and as you might expect the GL1800B seems to have more than enough to drive some crazy powerful lights and whatever other accessories you could dream up.
I plan to power my aux lighting using the fog light connectors and a quick look at the manual doesn't show a power rating, however, it shows the fogs being connected through a 20A fuse. As such, whatever wire gauge is being used is expected to handle a helluva lot of current and, hence, power.
Any of these high power lights, even multiples of them, should be as fine as sweet tea on a summer day. If you wanted to jump up to the Erica's from Clearwater, you could (6,000 lumens each).
Good lead . You made quite great homework .
It's just superficial... and loaded with unstated caveats mostly due to the fact that I don't have a full understanding. Most notably is that alternator output is lower at lower RPM (I wonder how much lower) and there are other power draws not on the list... like fans
Good question... could be as much as 200W... ? This question seems particularly important since the fans should only come on at low RPM.
If I am reading the manual correctly, the fans are fused @ 30A and the power amp is fused @ 40A. The amp seems to be fused rather high for 8 watts / channel.
As far as low RPM's is concerned, sitting at a stop light with lights, brake lights and accessories on @ idle was an issue with my former Vision. The stator would not kick in until faster than idle speeds. I would have to artificially keep the throttle on.
I have Clearwater Lights on my last five bikes ... Have been the best for more ... Great adjustment ...
I don't know where this 8 watts/channel rumor got started, but it ain't true! The amp puts out at least 40 watts/channel into 4 ohms.
This is a o'scope pic into a 4 ohm load. It's putting out 40 watts and is not even clipping yet.
100_3263.jpg
Albuquerque, NM