Need someone with a multimeter and a few minutes

[Pedro66]

Need someone with a multimeter and a few minutes who doesn't mind taking off the rear light

Bozo here in his rush to work on some of the rear light projects managed to cut the two wires going from the 6 pin connector to the brake lights before he wrote down the pin positions, normally this is not an issue until both wires are the same color so what I need is someone to pop off the rear light and tell me which pin on the 6 pin feeds each brake light as they have individual feeds left and right as you sit on the bike

Thanks

Pete

[Steve 0080]

That is not in the manual ???

[Pedro66]

That is not in the manual ???

Nope just shows 6 pin with no pin outs

[Bike44]

Are we talking about page 26-17 or 26-19 of the GL1800B/BD SM? No bike yet so can't go look.

Are you talking brake/combo or turn signal lights? What color wires were cut?

For the GL1800B IIAC = USA

Brakes: G/R = Brake, Br/W = Taillight, G = Ground...same for both bulbs.

Turn: Lb = Right, O = Left, G = Ground.

[Pedro66]

Are we talking about page 26-17 or 26-19 of the GL1800B/BD SM? No bike yet so can't go look.

Are you talking brake/combo or turn signal lights? What color wires were cut?

It's the green/red brake wires there are 2 they both common together towards the front but I need them splt for our mustang lights

[Bike44]

It's the green/red brake wires there are 2 they both common together towards the front but I need them splt for our mustang lights

Is Fig. 26-17 in the SM any help? I'll leave it at that as I'm not sure what you're trying to accomplish.

OK, got it: GL1800 Riders "New Mustang Light for 2012+" thread...looks very nice.