G'day everyone.
I fitted the Wingstuff genuine Honda marine volt meter and replacement panel today, but could not work out where to attach the wiring connectors ( power and earth) in either of the two wiring loom points located in the rubber boots on the right access panel , rt side of the fairing.
There are two separate white connector blocks with black caps ( with three vertical brass pins). My wiring connector on the volt meter has 2 pins in a horizontal plane. Do I use the small white connector block, and splice into it for power to the gauge, or is there a location that the two pin horizontal gauge connector will just plug in to? Unfortunately the online instructions were no help.
My bike is a 2015.
Thanks for any advice re this, as I was expecting simple plug and play.
Ken