Hi Greg,

Great minds think alike!

I actually was doing the same thing this afternoon; with epoxy. I didn't like how the lead wire flopped around in the housing. Here is the lead wire currently curing with the epoxy;



I've since studied the rear of the removable black center fender on the F6B; and have come to the conclusion that the lead wire will (unfortunately) have to be run (and -NOT- shielded by plastics) internally up along where the black center fender edge meets the side saddlebag edge.

However...

...in a moment of consumer weakness; also have ordered the vertical LED lights from Value Accessories today as well. Once all that does come in; I will rip apart (carefully disassemble) the rear center fender (again) and see if there's a better way to run the leads. For all of the LED lights.


Thanks for your response.