Friend of mine gave me a standard wing windshield to try on my F6. I liked the fact that it's wider than the tall F6 Honda shield but was not sure it was going to work since the wing shield is adjustable. I compared the tall Honda shield against the wing shield and even though the holes match up there is no way it would mount up and stay in place, slotted holes are way too big. Since I have nothing in it I decided to cut it down, I matched up the vent holes and marked the bottom and the mounting holes and cut it off. I drilled the center hole but had to mount it to find the exact location of the outer holes, marked and drilled them and it's a perfect fit and works way better than the tall F6 shield plus I think it looks better and it gives better wind protection, think I'll run this till my new Madstad arrives.