...into a body panel of your motorcycle, and then discovered that even after careful thought, measuring and planning, the accessory that you were going to install in it... doesn't fit?
...into a body panel of your motorcycle, and then discovered that even after careful thought, measuring and planning, the accessory that you were going to install in it... doesn't fit?
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537
Don't make me come there and fix your schiznit.
These folks have good plugs.
http://www.widgetco.com/hole-plugs?g...FYsvgQoddeAGAQ
[SIGPIC][/SIGPIC]
2015 F6B Deluxe
Matte Silver
Just about got my bike put back together, and wanted get the Gerbing power outlet mounted somewhere in front of me. Looked FOREVER for the perfect location and THOUGHT I found it:
The horror discovered, after I drilled the hole; was that the Gerbing power cable could not be routed (as I had previously thought possible) through the underlying gas tank spill tray structure underneath. I had eyeballed this placement every which way, and though it was possible.
There is the gas tank cover's hinge under there too... but the cable could be routed well enough to avoid it's operation.
I could compromise the integrity of the gas tank catch tray by drilling a hole in the side of it; for the cable to route through... but elect not to do that.
For now I just have another Gerbing power lead exiting out from the left side of the frame in front of me. I still could drill another hole ON THE SIDE of the gas tank cap cover WHICH WOULD allow enough clearance for the cable underneath to be routed (since that area is not in the gas tank spill tray area) ...but I am really not happy about having another hole off to the side of the gas cap cover.
Thanks for the link Stro... regarding the hole caps; I just need one. It would cost .18 cents but shipping is $3.95 Keerist.... I'll check locally or maybe just get a nice sticker/decal to put over the hole for now.
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537
Done something like that before,, me,, YUP a few times.
At least it is centered and a plug won't look out of place, and $4 is a pretty cheap screw up fix.
If it helps, this is what I did for the Gerbing gear. The Gas Cap door is about $25 if I decide to pull the wiring for a new bike.
I've spent most my money on Motorcycles and Women, the rest I just wasted.
If anyone ever see's my bike in person, you'll find a mistake covered area too. The sticker on the gas cover. When I removed it, I used my fingernail because I was too lazy to do it right. I now have an emblem covering that screw up.
“Gibraltar” 2016 white deluxe has been sold.
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537
Let me get this right you've got hot wires going to an area where your regularly spilling gas?? Sounds to me like a planned terrorist attack.
I would not be able to drill in to the painted plastic of my bike without crying the whole time. I was scared enough when I had to take the saddle bags apart to put the passenger backrest on.