Thanks!
I'm too cheap to pay for the specific plate. I used a scrap 3/16" aluminum sheet that I had and mounted it where the luggage rack used to mount (about 10" x 10" depending on how you do it). Then mounted their generic locking plate to that sheet. That stays on when the trunk is removed and looks pretty good.
I think the 3/16" is thick enough, but I might have gone with 1/4" if I bought a piece. I get a little bit of flex because the trunk is mounted almost completely "behind" the rack mounts. That is so I can leave the backrest on. If you remove the backrest, you can mount the trunk further up and will be more stable.
Albuquerque, NM
I did the same thing with chopped tour pack, even added the rack
On top to
20180526_08175620180526_081756.jpg
Last edited by shortleg0521; 07-12-2019 at 10:51 PM.
thumb_1561677808DAVE1692.jpgprpv (2).jpg
Harley slim tour pack with passenger backrest. 4 bolts and it's off!
Last edited by mjpgoski; 07-03-2019 at 04:04 PM.
2A0915CB-67C3-491C-9854-13CA82D669FE.jpg
I went with a BMW box.
2016 F6B Matte Grey
2016 XDiavel (Sadly...gone)
2014 M109r (FHD Classic) (Sadly...gone)
2014 VRSCF (Gone)
2006 VTX 1300C (Gone)
"I find as I get older that I have less and less to say about more and more. I thought I was mellowing as I got older, turns out I just don’t give a sh1t.”