Does anyone know what type of mount that is?
Dang Darcym - I see RAM mounts everywhere. I have the suction cup and the 2 ball set up off the clutch lever clamp. I'll post a pic.
John (Jay) Bettua
2014 F6b Red- sold 2016
2020 Goldwing Matte Black
Retired U.S. Air Force MSgt
I just found the two ball on the clutch lever clamp product, didn't know that existed before. I may swamp one of my one ball for the two balls. Can't have enough balls.
(that was a softball, btw)
btw: product number RAM-B-309-1U is the one ball, RAM-B-309-2U is the same product with two mounting balls.
2013 Honda F6B custom orange
2009 Kawasaki Versys aka "Dr Doom"
2009 Suzuki Burgman 650 "Stormtrooper"
2003 Suzuki Burgman 400 "Yoda"
Here is my Ram mounts!
Attachment 7073Attachment 7074
Can't live without them!
John (Jay) Bettua
2014 F6b Red- sold 2016
2020 Goldwing Matte Black
Retired U.S. Air Force MSgt
WingStuff has a bar that mounts to each side of the handlebar allowing all sorts of mounts. I am looking to use it for a Zumo/Touratech mount.
http://wingstuff.com/products/20071-...gl1800_2nd_gen
I have my Zumo mounted on the clutch perch using the Ram mount with ball but where can I hardwire this into the bike so that it only gets power when the key is turned on?
my old bike had a aftermarket shark audio system. my Garmin had an SDcard port. so music would play from the SD card into the amp. when a directional command came up, music would cut off, betty would say turn left and the tunes would come back on. with the on board system on our 6's how can I set this up again? we're running a jump drive from the back for tunes (radio up here sucks all talk no tunes pbbbt). I guess my question is if I can find a GPS that accepts jump drives or SDcards, can it be connected to the on board and get the same result?