Originally Posted by
BIGLRY
My Fenda Extenda came with the double sided tape and four plastic push/pull plastic rivets. I pulled the fender off the bike and dry fitted the extend just to see how close it matched the profile of the fender which was darn near perfect. After cleaning the tire side of the fender of any dirt & contamination with an alcohol wipe, I used the supplied double sided tape to stick it all together.
I then re-installed fender with the Extenda taped in place to again check fit & clearance. Confident all was good, I removed the fender with the extenda in place and drilled the four holes and inserted the push/pull rivets then reinstalled the fender. There was no template for drilling supplied with my Extenda, but you do get to look at the inside and outside of the fender(it is in your hand) for logical placement of the rivets and where to drill.
Tip: I put a band of masking tape across the fender where I was going to drill the holes so I could mark them and to prevent any slippage of the drill that would scratch the paint on the fender, then after drilling I removed the masking tape before installing the four push/pull rivets.