Passenger peg risers

[ths61]

Those rear floorboards do look nice.

Stro did a sweet job of refinishing them. He should start an F6B floorboard service !

[TailGunner]

If you want to refurb start here. Easy disassembly, cleaning and painting or powder coat or chrome.

http://www.ebay.com/itm/2007-07-HOND...2d3fc5&vxp=mtr

http://www.ebay.com/itm/HONDA-OEM-GL...b5308b&vxp=mtr

There are plenty of used or you can buy new. New do get pricey but are fresh.

Edit: just went and looked and there might be a half inch rise with the floorboards. No appreciable lift.

So they bolt right on correct. Seems cheap enough to try and if she likes it I can then clean them up and powder coat. Funny aftermarket haven't really come up with something. Thanks

[ths61]

So they bolt right on correct. Seems cheap enough to try and if she likes it I can then clean them up and powder coat. Funny aftermarket haven't really come up with something. Thanks

Yep, they use the same bolts as the pegs. They are @ $200 new on FleaBay and can be found used a lot cheaper. Mine were virtually in new condition.

[stroguy]

Those rear floorboards do look nice.

Stro did a sweet job of refinishing them. He should start an F6B floorboard service !

Thanks guys. If you go paint I have a bit of a heads up. If not it is no biggie. I had to refinish the left board with a bit of lack of attention.

[srt8-in-largo]

Good tip Tim.

Hey Tailgunner, if you're going this route definitely look around. IIRC Cosborn found his used on eBay for about $80.

[co425]

Just the thing I wanted to stumble on. My wife too has issues with the peg height. I'll be on the lookout for a set of used floor boards I can powder coat.

Nice looking floorboards by the way.

[Steve 0080]

Mine too....

[Elroy]

So they bolt right on correct. Seems cheap enough to try and if she likes it I can then clean them up and powder coat. Funny aftermarket haven't really come up with something. Thanks

Just the thing I wanted to stumble on. My wife too has issues with the peg height. I'll be on the lookout for a set of used floor boards I can powder coat.

Nice looking floorboards by the way.

I've got a set. I'll quadruple check with the wife this afternoon to make sure she DOES NOT want them. I put the mini-floor boards on the back for her but kept these around in case she changed her mind. She hasn't so far. I'll hopefully update this afternoon if I will have a set for sale.

[srt8-in-largo]

If you want to refurb start here. Easy disassembly, cleaning and painting or powder coat or chrome.

http://www.ebay.com/itm/2007-07-HOND...2d3fc5&vxp=mtr

http://www.ebay.com/itm/HONDA-OEM-GL...b5308b&vxp=mtr

There are plenty of used or you can buy new. New do get pricey but are fresh.

Edit: just went and looked and there might be a half inch rise with the floorboards. No appreciable lift.

I missed this; WOW! $25 and $30 per side...