Look at the video....the stuff sits in the middle area of the tire. It doesn't wash over the whole inside. It's thick enough not to get runny, but still enough to balance and not harden. I've never used it, but might give it a try after what I saw.
Look at the video....the stuff sits in the middle area of the tire. It doesn't wash over the whole inside. It's thick enough not to get runny, but still enough to balance and not harden. I've never used it, but might give it a try after what I saw.
The video looks good. I think I will try the Ride-On, too. I'm wondering, if you don't ride for a few weeks, or over the winter, does the gell settle at the bottom of the tire? Possibly having to re-distribute itself when riding starts again? And if it does settle, does the "gell" get stiff, when the weather gets cold? Any thoughts would be appreciated. Thanks!
John
External sensors should be fine.
Internal sensors are indeed susceptible to fouling from "inside the tire" liquids. The pressure ports on these things are only 1 or 2 mm diameter, and the sensor manufacturers warn very clearly that any debris blocking the port can result in bad readings. However... there are two ways of mounting internal sensors.
The first method attaches to the backside of the valve stem. Since RideOn is installed through the valve stem, this causes it to be in close proximity to the sensor and increases the odds of fouling. The second method attaches to a band around the center of the rim. In this case you can rotate the location of the sensor to be opposite the valve stem; now when you install RideOn, you won't be spraying it near the sensor and the odds are reduced of it getting fouled.
Brilliant idea on the color!
John IIRC some of these questions are addressed in the FAQ section of their website.
I seem to recall reading where the stuff does indeed settle in the bottom of the tire if the bike isn't ridden for a while, but I think it shouldn't take long to redistribute itself once the bike is moving again.
The Dyna beads have no effect on tire pressure monitors, I received that information right from Innovative Balancing. The company that sells Dyna beads.