It something difficult about some sensors making them hard to remove to add air? My Garmin sensors are no harder to remove than a normal valve stem cap. Still trying to understand the need for a "T".
It something difficult about some sensors making them hard to remove to add air? My Garmin sensors are no harder to remove than a normal valve stem cap. Still trying to understand the need for a "T".
Two words: Wear (and) tear. If you did this quite often, the sealing surface in the sensor could become worn out/damaged, or the sensor's housing could eventually fail.Originally Posted by 2wheelsforme
Plus... let's say that you remove a sensor to add air. You're going to have to then put it back on. You could lose a little air during that process of reinstalling it.
So much easier to just install the T-Valve, mount the sensor on top, and use the perpendicular stem valve to add (or remove are) as needed.
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537
Posting Permissions
Reply With Quote