Are those bolts metric or SAE?
Are those bolts metric or SAE?
[SIGPIC][/SIGPIC]
2015 F6B Deluxe
Matte Silver
The guy who invented the first wheel was an idiot -
the guy who invented the second one... he was the genius!
http://theringfinders.com/blog/Larry.Royal/
All taped up and ready for paint. But all I have at the moment is flat black BBQ spray paint
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537
Finished
Two coats of Krylon gloss black spray enamel.
Will get them mounted as soon as I source two new cotter pins... Most assuredly this will extend the life of the Kinetic Kury pegs. The stainless steel bolts "should" wear down more slowly than the pegs themselves...
...am interested in the first "scrapes" with them.
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537
They look sweet. Great work.
Wonder if you could have had a couple of nuts welded together, then had those nuts welded to the bottom of the peg. Then you could change the bolt out when she became worn.
[SIGPIC][/SIGPIC]
2015 F6B Deluxe
Matte Silver
That is a good idea... and that would work... though the bolt would hang a little lower if fastened into two JB Welded nuts; in the grooved slots... but not by much
...too late at this point though to modify it as such.
The 1/2" bolt does fit very snugly in the grooved slot underneath the Kinetic peg... once it wears out... I can play with a new design as you suggested. Unless someone beats me to it... Biglry
21 years Army (retired)
...been everywhere, seen everything, done almost everything.
IBA 80537