Tapered Seat Bolt Set, Honda F6B

[RickW]

Tell me what we did wrong then at my dealer trying to install the Mustang seat using these bolts purchased last summer..They were too short and would NOT allow seat rails to tighten..After screwing around for about 1/2 hour we used the stock bolts and the seat finally fit reasonably well...Still the rail on the right side sticks out from the seat a little, but I am living with it...Regards...Someone else on this board said that the after market bolts with not work with anything but the stock seat??Appreciate any advise on the best way to make these bolts work..Have they been up-dated since last year as I see your post says that will work on aftermarket seats and specifically the F6B??

You did not have these bolts. As I posted above, these are new and specific for the F6B.
We have specific GL1800 bolt kits also which are a different length.

These Seat Bolt Kits are correct for the F6b, these are actually slightly longer then stock plus the tip.
I installed a set on mine with a Mustang Seat and did compare the length of the stock bolts to these replacements.
These fit fine.

[opas ride]

You did not have these bolts. As I posted above, these are new and specific for the F6B.
We have specific GL1800 bolt kits also which are a different length.

These Seat Bolt Kits are correct for the F6b, these are actually slightly longer then stock plus the tip.
I installed a set on mine with a Mustang Seat and did compare the length of the stock bolts to these replacements.
These fit fine.

Rick, I don't doubt your info and I will assume these newer F6B "specific" bolts are longer and were made after I ordered the ones I did last spring...If they are indeed longer than the older style, I ordered from another supplier last year, I will place an order for the up-dated ones from Value Accessories soon...I will rely on your data that they indeed are longer than the older ones.....I remember ordering them for obvious reasons last year to use on the Mustang seat change and was very dis-appointed that they did not work....Thanks again....

[bob109]

Whether using the OEM Seat Bolts or the tapered end After Market Seat Bolts make sure you take the opportunity to clean/chase the threads on the frame bosses. Only takes a a few minutes and minimal effort to remove the "powder coat overspray" on the female threads. A light dab of Never Seize to the bolts is also a "plus". Stops "Galvanic Reaction" in its tracks

Here's the original post on the subject of cleaning the threads

http://hondaf6b.com/showthread.php?3...on-Improvement